39
05 The SnugStat will now restart, this may take a few moments. Once this
is complete the SnugStat has reset to factory setting.
Installation
This controller must be installed by a qualied electrician and must
comply with local installation regulations.
Step 1
Using a pozi screwdriver, loosen the screw from the bottom of the
thermostat, and then separate the front panel from the back plate.
Step 2
First place the front panel of the thermostat in a safe place.
of this manual.
Step 3
Step 4
plate and gently tighten the bottom retaining screw.
To Next Page
Loading...