Snuza HERO - Device Operation; Startup Procedure

9
the Alarm Indicator Light (4) flashes red and the full
audible alarm sounds.
The alarm can be deactivated by briefly pressing the
MODE/OFF button (7) or by turning Hero off completely
(press ON/OFF (6) and MODE/OFF (7) buttons
simultaneously). If the MODE/OFF button is used to
deactivate the alarm, monitoring will continue.
7.3 Travelling
Movement from external sources such as being pushed in a pram or travelling in a
vehicle or aircraft may be detected by Hero’s sensor. Hero should not be relied upon
where external sources of movement are present.
7.4 Clothing
• Herocanbeclippedontothefoldedwaistbandofthediaperorthewaistbandof 
elasticated pants, as long as the Movement Sensor (1) touches the baby in the
tummy area.
• Theremayalsobeathinlayerofclothing(egavest)betweentheSensorandthe
skin, but ensure that the Sensor maintains contact.
• Themonitorcanalsobeusedifbabyisdressedinlightclothing(forexample,a 
Babygro) over the nappy or pants to which the Hero is attached.
• Toomuchclothingmayattenuateormufethealarm.Makesurethealarmcanbe
heard if baby is covered in clothing and/or blankets.
7.5 Baby Sound and Video Monitors (Optional)
Hero can be used together with a baby sound or video monitor to extend the distance at
which the alarm can be heard.
8. SETTINGS
8.1 Audible Tick
This feature causes Hero to emit an audible ‘tick’ on each abdominal movement. To
enable the Audible tick, ensure that Hero is switched ON, and press the MODE/OFF
button (7) briefly (less than 1 second). To increase the volume of the tick, press the
MODE/OFF button once again for medium volume and again for high volume.
ENGLISH
HERO TYPE USA.indd 9
2014/11/11 12:52 PM