Socket 1D - Page 101

APPENDIX E: COMMAND BARCODES FOR CHS 7C 101
IMPORTANT! Print out the page to scan the barcodes. Do not scan them onscreen.
Factory Defaults
Factory Reset
Configures the CHS 7C to revert all settings to factory defaults. The CHS will power
o
scanning this barcode.
Data Editing – Suffix
Note: These command barcodes are compatible only with Revision B or later of the CHS 7C.
Data As Is (Default)
Configures the CHS to
return only the
decoded data (i.e.,
prefix and suffix are not
sent).
Suffix – Carriage
Return
Configures the CHS to
add a carriage return at
the end of decoded
data.
Suffix – Tab
Configures the CHS to
add a tab at the end of
decoded data
Suffix – Carriage
Return & Line Feed
Configures the CHS to
add a carriage return
and line feed at the end
of decoded data.
VIN Prefix Removal
Scan to Enable Description Scan to Disable
Return only the
last 17 characters
of a Code 39
barcode.