Socket 1D - Page 107

APPENDIX F: COMMAND BARCODES FOR CHS 7E, 7M, 7P, 7NRX 107
IMPORTANT! Print out the page to scan the barcodes. Do not scan them onscreen.
Factory Defaults
Factory Reset
Configures the CHS to revert all settings to factory defaults. The CHS will power off
scanning this barcode.
Data Editing – Suffix
Data As Is (default)
Configures the CHS to
return only the decoded
data (i.e., prefix and
suffix are not sent).
Suffix – Carriage
Return
Configures the CHS to
add a carriage return at
the end of decoded data.
Suffix – Tab
Configures the CHS to
add a tab at the end of
decoded data.
Suffix – Carriage
Return & Line Feed
Configures the CHS to
add a carriage return and
line feed at the end of
decoded data.