Socket 1D - Page 97

APPENDIX E: COMMAND BARCODES FOR CHS 7C 97
Factory Defaults
Factory Reset
Configures the CHS 7C to revert all settings to factory defaults. The CHS will
power off after scanning this barcode.
Data Editing – Suffix
Data As Is
Configures the CHS to
return only the decoded
data (i.e., prefix and
suffix are not sent).
Suffix – Carriage
Return (default)
Configures the CHS to
add a carriage return at
the end of decoded data.
Suffix – Line Feed
Configures the CHS to
add a line feed at the
end of decoded data.
Suffix – Carriage
Return & Line Feed
Configures the CHS to
add a carriage return and
line feed at the end of
decoded data.
Suffix – Tab
Configures the CHS to
add a tab at the end of
decoded data
Compatible with only
Revision B or later of the
CHS 7C