Socket CX3391-1849 - Page 24

Setup Basic Mode
Wndows
In this mode the scanner functions and communicates similar to a
keyboard. Therefore, scanner will work with Notes, and any other
application that support an active cursor.
1. Turn Bluetooth on for your device. Go to Settings > Bluetooth. A
Bluetooth Devices search will begin.
2. Tap Socket S700[xxxxxx] in the list of Devices found. After a few
seconds the status will change to “Connected” or “Paired” and the
scanner blue light will stop blinking and turn solid blue.
Now you are ready to scan barcodes!
24