8
Getting Started
1. Pre-washing your PAP Equipment
Use a fragrance-dish soap with 4 liters of
water to wash your PAP equipment (mask,
hose, and reservoir), then rinse thoroughly
with clean water.
Note: The SoClean uses no fluids in its
operation. Pre-washing your equipment
helps neutralize pre-existing odors. DO
NOT immerse your SoClean in water.
2. Installing the Injection Fitting
The injection fitting connects the SoClean
to your PAP machine. Once installed, you
do not need to disconnect the injection
fitting to use your PAP. You may leave the
SoClean connected to your PAP. If you
need instructions for connecting to your
specific PAP model, please visit our website
www.betterrestsolutions.com.
With humidifier: Disconnect your PAP
hose from your PAP machine. Position
the injection fitting onto the port of your
humidifier, allowing the smaller tubing to
enter into the reservoir. The end of the
tubing should rest on or near the bottom
of the reservoir, over the heat plate. If
necessary, carefully trim the injection tubing
in increments until it is the correct length.
To Next Page
Loading...