TROUBLE REMOVAL
3.The feed speed is unstable
（1）Check the pressure of the compressor is enough or not
（2）To check the pressure gauge of machine is sufficient or not
（3）Check the oil in the oil converter is adequacy or not
（4）Check the degree of lubrication of all sliding mandrels is adequate or not
4.The workpiece is clamped lossen ,and are pushed out when the feed:
（1）The speed of feed is too fast when cutting and chamfering,and the friction coefficient of
different materials is not same. So can not produce the mould suitable for all materials.So the
correct approach is to slow the speed of feed and despinning.
(2) The force of friction is reduced on workpiece and mould surface. And please keep those surface
dry.
To Previous Page
Loading...