Need help?Do you have a question about the SOCO EF-AC/80 and is the answer not in the manual?
Understand manual, clear area, memorize emergency stop, use safety shield, proper clamping.
Power off for blade replacement, daily maintenance, pre/post shutdown lubrication, mandrel lubrication.
Ensure machining tools meet specifications or consult sales department.
Manually load material, machine clamps, feeds, retracts, and chamfers automatically.
Precision engineered molds and standard blades for simple replacement.
Lists the chamfering machine, adjustable blade knife, clamping molds, and wrenches.
Model EF-AC/80, Motor Specifications 415v 2.2KW.
Spindle speeds are 800r/min (low) and 1600r/min (high), for various metal tubes and bars.
The machine can process workpieces with a diameter range of 10-30mm.
Prepare power, air, tools, and install the machine by connecting air and checking motor direction.
Adjust pressure gauge, blade holders, feed rate, switch to auto mode, and test machine.
Fill oil on shaft, clean metal shavings, wipe and oil the machine daily.
Use SAE10 oil, check hydraulic system, and change circulating oil every six months.
Replace blades based on workpiece material; note specifications for triangular and quadrilateral blades.
Address issues like mismatched molds, incorrect raw material facing, or unsuitable blade material.
Correct wavy end faces by adjusting feed rate and moderative block position.
Check compressor pressure, machine pressure gauge, oil converter, and mandrel lubrication.
Slow feed speed and ensure proper friction on workpiece and mold surfaces.
General| Brand | SOCO |
|---|---|
| Model | EF-AC/80 |
| Category | Industrial Equipment |
| Language | English |
To Next Page