APPLCATION INSTRUCTION
1.Preparation of Application
(1) This machine uses a three-phase power supply,and make sure the machine power
supply to match the voltage.
(2) This machine uses compressed air pressure which is greater than 1HP.
(3) check the machine structure is no problem, and all tools are all ready.
2.Installation of a machine
（1）Turn on the power
（2）Connecting air hose to the machine air interface.
（3)Confirmed the steering of motor is on right direction- Note: Steering error will
damage the machine and the blade
（4）Replace different blades depending on the form of chamfering
To Next Page
Loading...