TROUBLE REMOVAL
1.chamfering uneven
（1）Maybe Moulds do not match spindle well. You can loose four screws on fixing mould and
change to manual mode. Put material into it and fix it. And then fasten four screws.
（2） Raw material facing end vertical not well
（3） Size of mould is too big and can not fix well when chamfering
（4） Blade material is not suitable for cutting the workpiece
2.The end faces appear wavy lines
Feed rate is too fast.The machine feed include fast feed at first step and cutting at the second step.
The position of the moderative block depends on the feed speed , and put the block at the righter
position the cutting processing is sooner.During fast feed process and retraction process the spindle
are the fastest feed speed. And during cutting stroke,feed rate was controlled by the control valve,
data is bigger the speed is faster.
To Next Page
Loading...