Need help?Do you have a question about the socomec ATI 630 A and is the answer not in the manual?
General| Brand | socomec |
|---|---|
| Model | ATI 630 A |
| Category | Control Panel |
| Language | English |
Explains the components and features of the motorized changeover switch.
Details the parameters within the Setup menu, including definition, range, and default values.
Explains the procedure for modifying parameters, using network voltage as an example.
Details the 8 parameters in the Voltage menu for detecting over/under voltage conditions.
Details the 8 parameters in the Frequency menu for detecting over/under frequency conditions.
Details the 5 parameters in the Timers menu for loss of mains, stabilization, return, etc.
Explains how metering is active and displays various measurements like voltage, frequency, and power.
Explains how to access and operate the unit in manual mode, including manual operation, padlocking, and keyswitch.
Explains how to activate and use the automatic mode for generator start and source switching.
Describes the sequence triggered by a loss of mains, including specific features and flowchart.
Describes the sequence for mains return, including specific features like retransfer inhibit.
Provides a flowchart detailing the mains return automatic sequence logic.
Explains how to access and exit test modes using the test pushbutton and code.
Explains how to perform off-load testing of the generator, including sequence and description.
Explains on-load testing, keypad activation, and remote activation via input.
Introduces the electronic module's front panel, including LCD, LEDs, buttons, and keyswitch.
Explains conditions for product programming (Automatic/Manual mode).
Details the steps to access test modes, including entering the code 4000.
Details how to access the programming mode using the keypad and code.
Details the parameters within the Setup menu for metering, including definition, range, and default values.
Explains how to modify parameters in the metering product setup.
Details the 8 parameters in the Voltage menu for metering, covering over/under voltage detection.
Details the 8 parameters in the Frequency menu for metering, covering over/under frequency detection.
Details the 5 parameters in the Timers menu for metering functions.
Explains metering activation, display behavior, and available measurements.
Explains manual mode functionality for the metering product, similar to the basic product.
Explains how to access and exit test modes for the metering product.
Details the electronic module's front panel, including LCD, LEDs, buttons, and keyswitch for metering.
Describes conditions for programming the metering product.
Describes the mains return sequence for the metering product.
Details accessing test modes via the test pushbutton and code for metering.
Details how to access the programming mode for the metering product.
Troubleshooting for automatic operations availability issues.
Troubleshooting for transfer failures to genset during mains failure or test.
Troubleshooting for transfer failures to mains after mains return or test end.
To Next Page