Need help?Do you have a question about the socomec ATI 800 A and is the answer not in the manual?
General| Display type | LCD |
|---|---|
| Altitude | Up to 2000 m |
| Connection | Screw terminals |
| Communication protocol | Modbus RTU |
| Rated current | Depending on the connected ATS |
| Rated operational voltage Ue | Depending on the connected ATS |
| Rated short-time withstand current Icw | Depending on the connected ATS |
| Mechanical durability | N/A (Electronic device) |
| Electrical durability | N/A (Electronic device) |
| Protection degree | IP20 |
| Relative humidity | 95% at +40°C |
Description and connection details for current inputs used in metering functions.
Activation and operation of the automatic transfer switch functionality.
Description of the automatic sequence triggered by mains failure.
Description of the automatic sequence when mains supply is restored.
Steps and procedures for programming metering device parameters.
Configuring network parameters, voltage, frequency, and timers.
Settings for over/under voltage detection levels and hysteresis.
Settings for over/under frequency detection levels and hysteresis.
Configuration of timers like loss of mains and retransfer delays.
Detailed overview of metering functions, electrical values, and power measurements.
How to operate the metering device manually.
To Next Page