After entering the "WATER MEASUREMENT" mode, probe calibration is
performed. When calibrating, the probe must not be in the water. After
calibrating, recommendations on how to dip the probe in the water will
be displayed. It is necessary to dip the probe into water, wait until
temperature stabilizes (indication will be shown in upper right corner of
the display) and press MEASURE icon on the display or OK button on
the device.
ATTENTION! Do not dip the probe below the shown in the picture depth, because this may
damage the device.
After measurement, information about solids content in the water is displayed.
- low hardness water- water is suitable for drinking;
- medium hardness water - water is suitable for drinking in small amounts;
- hard water- water is not suitable for drinking.
To Next Page
Loading...
Need help?
General
