Software House RM2-SE User Manual

Features
3
Features
 Compatibility with most 125 KHz Proximity formats, HID iCLASS, iCLASS
SE, iCLASS SEOS cards, and MIFARE ISO 14443A credentials (badges,
disk tags and key fobs). Reads both 125 KHz and 13.56 MHz credentials in
the same reader.
 Electrical protection (reverse polarity diode protection on power lines).
 Data lines: high-speed transient voltage suppressor diodes.
 IP65-rated sealed electronics for deployment in both interior and exterior
environments.
 Beep-on-card defaults to ON.
 Controller Communications
• RM RS485 half duplex
 Open Standards Compliance
• ISO 14443A
• ISO 14443B
• ISO 15693
 CASI ProxLite
• 44-bit pass-through
Specifications
The following specifications apply to the readers:
 Data Cable: Recommended data cable is Belden
®
#9841or equivalent. The
maximum length is 4000 feet (1212 meters) between the controller and the
reader.
 Power Wiring: Recommended power wiring is Belden #8461/8442 twisted
pair. Maximum length depends on the wire gauge. The reader can be
powered from a local power supply.
 Temperature Indoor/Outdoor
• -31°F to 149°F (-35°C to 65°C)
NOTE
UL has not evaluated IP65 rating.
NOTE
Not all features have been evaluated by UL.

Software House RM2-SE Specifications

General

Brand	Software House
Model	RM2-SE
Category	Rfid Systems
Language	English