17
en
Programming
Access the hour setting function. The first two digits will flash.
1 Press “+” and “-” to select the correct hour.
2 Press the PROG button (9) to confirm the hour.
i The hour will be saved to memory. Now access the minute setting
function.
3 Press “+” and “-” to select the minutes.
4 Press the PROG button (9) to confirm the minutes.
i The minutes will be saved to memory. Now access the day setting
function.
Setting the Day of the Week (fig. 14)
i The current day of the week must be saved to memory so that the heater
will start to operate on the expected day.
i The icon for the 7 days of the week will be displayed, with the first day of
the week selected.
1 Press the “+” and “-” buttons to move through the days of the week until
you reach the correct number for today. (e.g. Monday=1, Tuesday=2,
Wednesday=3, etc.).
2 Press the PROG button (9) to confirm the current day of the week.
i The number for the day of the week will be saved to memory.
i The time and day of the week must be reset in the event of a power cut.
Saving the Operating Schedule to Memory (fig. 15)
i If not reset by the user, the heater will operate according to the factory
default schedule settings.
i Access the first day of the week for programming.
1 Choose the required operating mode for each time band.
To do this: Select the desired time band. Press the button for the desired
operating mode: comfort (13), economy (14) or anti-frost (15).
i Comfort mode display:
Economy mode display:
Anti-frost mode display: Blank space
2 Press the “+” button to confirm the selection and then select the next time
band.
3 Press the “-” button if you need to return to a previous time band.
ET8934_36_38_40_42.book Page 17 Thursday, July 9, 2009 9:22 AM
To Next Page
Loading...
