SOLAC LUCID i10 - Cleaning Modes; Operational Cleaning Modes; Return to Charging Station

CLEANING MODES
AUTO CLEANING MODE
- The robot starts to vacuum automatically and
combines the different cleaning modes in one
optimizing the cleaning of your home to the
maximum. To use the AUTO cleaning mode,
press the button (AI) on the remote control.
- When the cleaning cycle ends or if the battery
runs out, it returns to the charging base auto-
matically.
SPIRAL CLEANING MODE
- The robot starts vacuum at a particular point by
spiraling outward approximately (1 meter) in
diameter and then spiraling inward to where it
started. To use the spiral cleaning mode, press
the (AO) button on the remote control.
MAX CLEANING MODE
- The robot increases its suction power to
provide a deeper cleaning.
- To use the MAX cleaning mode, press the (AR)
button on the remote control.
- MAX cleaning mode can only be activated
during operation in AUTO cleaning mode.
EDGE CLEANING MODES
- Once the robot nishes cleaning the open
areas of your oor, use the perimeter mode to
make sure it has been cleaned along the walls
and around the legs of the furniture.
- If you prefer a faster cleaning of the edges,
press the button (AP) on the remote control.
SMALL ROOM CLEANING MODE
- When it is necessary to clean a specic room,
press the room cleaning mode button on the
remote control (AQ).
- When the cleaning is nished, the robot will
stop.
- Make sure to close the doors of the room while
using this mode.
GO HOME MODE
- Mode of return to the charging base automati-
cally when the robot detects that only 15% of
the battery is left.
BATTERY CHARGE:
- Warning: A new battery does not come with a
full charge and must be fully charged before
using the device for the rst time.
- Charge the battery at room temperature bet-
ween 4 and 40ºC.
- Turn on the ON / OFF button located on the
bottom of the robot.
- Put the robot in the charging base and ensure
that the automatic charging poles are aligned
correctly.
- Operation button (D): the red LED will light
blinking. When the LED stops blinking the robot
is loaded. Load the robot for 4 hours before the
rst use.
ACTIVATE THE ROBOT
- Before starting use, ensure that the power
switch (R) is on.
- Press the operation button (D) to awaken the
robot.
- Press the operation button (D) to start cleaning
in AUTO (AI) mode, you can also start cleaning
by pressing the AUTO button on the remote
control.
- NOTE: If the battery is about to run out, the
robot will return to the charging base automati-
cally to recharge.
- NOTE: If the load base is inaccessible, the
robot can not be recharged, it will return to the
initial situation and the cleaning system will
end. In this case, place the robot manually in
the charging base so that it can be recharged
correctly.
PAUSE THE ROBOT
- To stop the robot press the operation button (D)
or press the on / off button (AL) on the remote
control.
- To resume the cleaning cycle, press the opera-
tion button (D) again.
- For the robot to return to the charging base (U)
press the Go Home button (AJ).
POWER OFF THE ROBOT
- To turn off the robot press the operation button
(D) next until the operation indicator goes off.