SOLAC LUCID i10 - Maintenance and Indicators; General Maintenance Procedures

LED INDICATOR
LED LIGHT ROBOT STATUS
Flashing blue Charging
Solid blue Standby / Cleaning /
Fully charged
Solid pink Low power and returning
to Charging Dock
Off Robot is off. To conserve
power, the light auto-
matically turns off when
robot is not docked to
the charging doc and
has been inactive for 1
minute.
Flashing / Solid
Red + Beeping
Robot has an error. Re-
fer to the troubleshooting
section ”Anomalies” in
this manual for solutions
MAINTENANCE
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washingup liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Never submerge the connector in water or any
other liquid or place it under running water.
LUCID i10 CLEANING REPLACEMENT
FREQUENCY
Dust Bin After each
use
-
Filters Once every
week
Every 2 months
Rolling Brush Once every
week
Every 6-12
months
Side Brushes Once every
month
Every 3-6
months(or when
visibly worn)
Sensors Once every
month
-
Charging
Pins
Once every
month
-
Swivel wheel Once every
month
-
EMPTYING THE POWDER TANK:
- Empty the dust container after each use.
- Uncouple the dust container from the applian-
ce.
- Open the emptying lid of the tank where
indicated by the arrows and pour its contents
into an appropriate waste container.