SOLAC LUCID i10 - Component Care and Replacement; Filter and Brush Maintenance; Battery and Mop Care

CHANGE OF FILTERS:
- Disconnect the powder container from the
appliance.
- Open the lid of the lter compartment located
in the upper part of the dust tank.
- Extract the lter and shake lightly to expose the
dust.
CAMBIO DE BATERIA:
- Unscrew the screw of the battery cover and
remove the cover.
- Disconnect the plug between the battery and
the robot.
- Insert the new battery, connect it to the robot
and close the lid.
CLEANING MOP
- Remove the tank lid.
- Wash the mop with water and let it dry.
CLEANING ROBOT’S MAIN ROTATIVE
BRUSH AND SIDE BRUSHES:
- Open the compartment lid, remove the brush
and clean the compartment with a damp cloth.
- Clean the central rotating brush. Cut the hair
wrapped in the brush with the blade that
includes the selfcleaning brush.
LED INDICATOR
LED LIGHT ROBOT STATUS
Flashing blue Charging
Solid blue Standby / Cleaning /
Fully charged
Solid pink Low power and returning
to Charging Dock
Off Robot is off. To conserve
power, the light auto-
matically turns off when
robot is not docked to
the charging doc and
has been inactive for 1
minute.
Flashing / Solid
Red + Beeping
Robot has an error. Re-
fer to the troubleshooting
section ”Anomalies” in
this manual for solutions
MAINTENANCE
- Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
- Clean the equipment with a damp cloth with a
few drops of washingup liquid and then dry.
- Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
- Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
- Never submerge the appliance in water or any
other liquid or place it under running water.
- Never submerge the connector in water or any
other liquid or place it under running water.
LUCID i10 CLEANING REPLACEMENT
FREQUENCY
Dust Bin After each
use
-
Filters Once every
week
Every 2 months
Rolling Brush Once every
week
Every 6-12
months
Side Brushes Once every
month
Every 3-6
months(or when
visibly worn)
Sensors Once every
month
-
Charging
Pins
Once every
month
-
Swivel wheel Once every
month
-
EMPTYING THE POWDER TANK:
- Empty the dust container after each use.
- Uncouple the dust container from the applian-
ce.
- Open the emptying lid of the tank where
indicated by the arrows and pour its contents
into an appropriate waste container.