solamagic IR 02004 - Installation: Radiant Heaters with Pivoting Hinges


102
• Determine the appropriate mounting sepa-
ration of the pivoting hinges on the heater.
• Secure the ceiling plates at the selected
separation using suitable fasteners on the
wall/ ceiling.

     
     

• Tighten the hinges on the t-nuts until they
can no longer move relative to the heater,
tighten the M3 grub screws.
• Adjust the hinges until the desired tilting di-
rection is achieved.
• Position and tighten the M5 grub screws in
the ceiling plates.

     

     

