UNIT ASSEMBLY AND SETUP
CHARGING INSTRUCTIONS
Batteries have already been installed in units and are ready for immediate use. We recommend charging the
unit upon receiving, so you will have maximum power for your jumping needs.
1. Unwrap AC power cord from unit and plug into 120VAC outlet.
2. Charger will read internal battery status and apply the proper charge needed within 3-5 seconds.
3. When batteries are fully charged the AMPS gauge (left gauge) will read 2 Amps.
4. Unplug and rewrap AC power cord.
5. Unit is ready for use.
To Next Page
Loading...
