App Bulletin 100
Dec 06, 2011 5
4. Alternate Solution #3 – Install WiFi Adapter from Power Manager to Internet
Router
Use a Netgear WNC2001 Ethernet to WiFi (wireless) Adapter when the building’s
Internet solution uses a WiFi connection to the Internet router.
The Netgear adapter
uses an included AC/DC wall power plug for power and may require an
environmental enclosure depending on installation site requirements.
1.
Follow the Netgear instructions to install
any required WiFi network security.
2. Verify the PC/laptop can access the
Internet using the Netgear adapter.
3. Remove the Netgear adapter from the
4. Connect the end of the adapter’s Ethernet
cable to the Power Manager. Thread the
cable through the opening in the Power
Manager as shown on page 2.
5. Verify the adapter LED lights indicate
good signal strength and active
connections. Verify the Power Manager
LCD home screen displays COMMS which
indicates successful Internet, usually
within 5 minutes.
To Previous Page
Loading...
Need help?
General