SolarEdge EV Charger User Manual

EV Charger Cable Installation and EV Charger Configuration
Contents
EV Charger Cable Installation and EV Charger Configuration 1
Introduction 1
Package Contents 1
Required Equipment 1
Mounting the EV Charger Cable 1
EV Charger Activation and Configuration 3
EV Charger Configuration and Monitoring 4
Specifications 5
Charging Instructions 5
Version History
l Version 1.1, Apr 2018 - Clearance updated; addition of operating instructions
l Version 1.0 , Feb 2018 - Initial release
Introduction
The EV Charger Cable is used with SolarEdge‘s EV Charging Single Phase Inverter (referred to as inverter). This document describes how to install and connect
the cable and how to configure the EV Charger.
Package Contents
l A holder that is mounted on a wall/ pole (screws are not included)
l EV Charger Cable
l Cable lock
Required Equipment
l 4 screws
l Screwdriver
l Drill
NOTE
Connection to the SolarEdge monitoring platform is required for first EV charging.
Mounting the EVCharger Cable
Install the EV Charger Cable after the inverter is already installed (refer to the Inverter Installation Guide).
1.
Connect the EV charger Cable to the inverter (see Figure 1):
a. Align the two white arrows on the EV charger cable connector with the white dot on the inverter connector located at the bottom of the inverter: the
dot should be between two arrows.
b. Plug the connector into the EV connector.
c. Rotate the cable connector clockwise to fasten it.
EV Charger Cable Installation and EV Charger Configuration MAN-01-00445-1.1
1
Figure 1: EV cable connection

SolarEdge EV Charger Specifications

General

Mounting Type	Wall-mounted
Charging Standard	IEC 61851-1
Input Voltage	230 V AC
Output Voltage	230 V AC
Output Current	32 A
Connectivity	Wi-Fi, Ethernet
Enclosure Rating	IP65
Protection Features	Overcurrent, Overvoltage, Ground Fault
Operating Temperature	-30°C to +50°C
Certifications	CE
Smart Functionality	Yes

Summary

EV Charger Activation and Configuration

Monitoring Platform Mobile Application

Access the SolarEdge monitoring platform using the mobile application for EV charger management.

EV Charger Activation Screen

The screen indicating the EV Charger status and the option to activate the charging.

EV Charger Configuration and Monitoring

Prerequisites for Configuration

Ensure inverter and EV charger cable are installed and charger activation is complete.

Accessing Configuration Screens

Navigate to EV charger settings via the SolarEdge monitoring mobile application.

EV Charger Functionality Overview

Description of features and options available on the EV charger configuration screens.

Specifications

Charging Instructions

Connecting and Charging

Steps for connecting the EV charger plug to the vehicle and initiating charging.

Disconnecting and Storing

Procedure for safely disconnecting the EV charger and storing the cable.