78
Solarpower24.it by Barba S.r.l. – via Locchi, 3F – 47122-Forlì – Italia
Tel/What’s up +39 05431995799 – web www.solarpower24.it – email solarpower24@solarpower24.it
Back to grid
voltage/SOC
When “SBU” or “SOL” is set as output source priority and battery
voltage is lower than this setting voltage or SOC, unit will transfer to
line mode and the grid will provide power to load.
Back to discharge
voltage/SOC
When “SBU” or “SOL” is set as output source priority and battery
voltage is higher than this setting voltage or SOC, battery will be
allowed to discharge.
Charger source
priority:
To configure charger source priority.
Max. charging
current
It’s to set up battery charging parameters. The selectable values in
different inverter model may vary.
Please see product manual for the details.
Max. AC charging
current:
Float charging
voltage
Bulk charging
voltage
It’s to set up battery charging parameters. The selectable values in
different inverter model may vary. Please see product manual for the
details.
Battery
equalization
Enable or disable battery equalization function.
Real-time
Activate Battery
Equalization
It’s real-time action to activate battery equalization.
Equalized Time
Out
To set up the duration time for battery equalization.
Equalized Time To set up the extended time to continue battery equalization.
Equalization
Period
To set up the frequency for battery equalization.
Equalization
Voltage
To set up the battery equalization voltage.
Enable/Disable
Functions
LCD Auto-return
to Main screen
If enable, LCD screen will return to its main screen after one minute
automatically.
Fault Code
Record
If enabled, fault code will be recorded in the inverter when any fault
happens.
Backlight If disabled, LCD backlight will be off when panel button is not operated
for 1 minute.
Bypass Function If enabled, unit will transfer to line mode when overload happened in
battery mode.
Beeps while
primary source
interrupt
If enabled, buzzer will alarm when primary source is abnormal.
Over
Temperature
Auto Restart
If disabled, the unit won't be restarted after over-temperature fault is
solved.
Overload Auto
Restart
If disabled, the unit won’t be restarted after overload occurs.
Buzzer If disabled, buzzer won’t be on when alarm/fault occurred.
L2
output) setting
Battery Cut off
Voltage/SOC L2
To set the battery stop discharging voltage or SOC on L2 output.
To Next Page
Loading...