Solartronics FS1000 - Safety when installing the device; Safety when connecting the device electronically

5
E N
N L
. Store the device in a dry and cool place.
2.3 Safety when installing the device
DANGER!
. Never mount the device anywhere where there is a risk of gas or dust explosion.
CAUTION!
. Ensure that the device is standing firmly.
The device must be set up and fastened in such a way that it cannot tip over or fall down.
NOTICE!
. Do not expose the device to a heat source (such as direct sunlight or heating). Avoid
additional heating of the device in this way.
. Set up the device in a dry location where it is protected against splashing water.
2.4 Safety when connecting the device electronically
DANGER! Danger of electrocution
. If you are working on electrical systems, ensure that there is somebody close at hand
who can help you in emergencies.
WARNING!
. Make sure that the lead has a sufficient cross-section.
. Lay the cables so that they cannot be damaged by the doors or the bonnet.
Crushed cables can lead to serious injury.
CAUTION!
. Lay the cables so that they cannot be tripped over or damaged.
NOTICE!
. Use duct-work or cable ducts if it is necessary to lay cables though metal panels or
other panels with sharp edges.