SolaX Power SK-SU3000 - Troubleshooting - Faults and Solutions

Troubleshooting
55
Faults Diagnosis and solution
C1 Boost OVP
The Boost voltage of the charger over limit.
• Wait for a while to check if back to normal.
• Or. Seek for help from us.
The battery voltage is over limit.
• Wait for a while to check if back to normal.
• Or, Seek for help from us.
The charger is over current protected.
• Wait for a while to check if back to normal.
• Or, Seek help from us.
The boost current of the charger is over limit.
• Wait for a while to check if back to normal.
• Or, Seek help from us.
C1 Bat OVP
C1 Charger OCP
C1 Boost OCP
CT Fault
The CT or the meter is not connected well.
Check the connection of the C T or the meter.
Or, Seek help from us.
•
•
RC Fault
DCI over current protection Fault.
• Wait for a while to check if back to normal.
• Or seek for help from us.
DCI OCP Fault
DCI over current protection Fault.
• Or seek for help from us.
Other device Fault
Other device fault.
• Or seek for help from us if can not back to normal.
• Wait for a while to check if back to normal.
• Turn off the PV, battery and grid , reconnect them.
SW OCP Fault
Over current fault detected by software.
• Turn off the PV, battery and grid , reconnect them.
• Or seek for help from us if can not back to normal.
Dm9000 Fault
Network DSP fault.
• Turn off the PV, battery and grid , reconnect them.
• Or seek for help from us if can not back to normal.
RTC Fault
RTC Fault
• Turn off the PV, battery and grid , reconnect them.
• Or seek for help from us if can not back to normal.
Mgr EEPROM Fault
Manager EEPROM Fault.
• Turn off the PV, battery and grid , reconnect them.
• Or seek for help from us if can not back to normal.