Password
The default password is “0000”for end user, which only allows the user to
review the current setting and some easy setting. If professional change is
needed, please contact with the distributor or factory for installer password.
We need to increase or decrease the word by pressing up or down button.
Press OK to confirm an alternate to the next word. After word is confirmed,
,press “OK” to enter password.
●Settings
Setting function is used for setting the inverter for time, connection, Grid
and so on.
Since this function will change the inverter's parameter, the end user with
the user password as”0000” has the limited authority to change the setting.
We need installer password to do most of the professional setting.
﹦﹦ ﹦ ﹦Password ﹦﹦ ﹦ ﹦
0 0 0 0
﹦﹦ ﹦ ﹦Safety ﹦ ﹦ ﹦ ﹦
country
VDE4105
﹦﹦ ﹦ ﹦
Load ﹦ ﹦ ﹦ ﹦
L1 Power
0W
Setting
If inputting the installer password, the information of the LCD interface is
as below.
a) Safety
The user can set the safety standard here. According to different countries
and grid tied standards. There is several standards for choice (May change
without notice.)
b) Solar
This status shows the real time PV condition of the system,
such as input voltage, current and power situation of each PV input.
Press up and down button to review parameter, Press “ESC” to return to Status.
﹦﹦ ﹦ ﹦
Solar ﹦﹦ ﹦ ﹦
U1 0.0V
I 1 0.0A
P1 0.0W
c) Load
If the inverter is plugged in a smart plug, this status shows the real time
load power, include load1 power and load 2 power.
Press up and down button to review parameter, Press “ESC” to return to
Status.
Item
1
2
3
Country
Standard
VDE 4105
IEC 61727
En50549
Australia
German
4
As4777
Item
Country
Standard
Netherland
India
﹦﹦ ﹦ ﹦
Grid ﹦ ﹦ ﹦ ﹦
Ua
0
.0 V
Ia 0.0A
Fa
00.00Hz
32 33
Operation MethodOperation Method
To Next Page
Loading...
Need help?
General
