INSTALLATION
2. INSERT BULB INTO CHAMBER:
IMPORTANT:
HANDLE THE BULB BY THE ENDS ONLY AND AVOID TOUCHING THE CLEAR GLASS OF THE
BULB. IF POSSIBLE USE COTTON GLOVES TO HANDLE BULB TO AVOID GETTING OILS FOM
HANDS ON THE BULB. SKIN OILS ATTACH TO THE BULB AND SHORTEN ITS EFFECTIVE LIFE. IF
BULB IS TOUCHED, WIPE CLEAN WITH A SOFT CLOTH AND RUBBING ALCOHOL.
A. Unthread and remove the end cap with the wire attached from the end of the UV chamber
B. Plug the 4 prong plug into the end of the UV bulb
C. Slide bulb back into chamber
D. Rethread cap back onto chamber fitting (hand tighten only)
A B
C D
5
To Next Page
Loading...
