INTRODUCTION
The Saltron produces a pure form of chlorine by electrolysis of salt (NaCl) in order to sanitize your pool water. After the salt is converted to Chlorine and the bacteria
are killed, the chlorine converts back to salt and this process is ongoing. The salt concentration used is very low (less then that in a human tear). Chlorine can be
easily destroyed by ultraviolet light from the sun so it is always a good idea to run the Saltron as much as possible during the night hours along with the pool pump
system. That way the chlorine generated is not immediately destroyed by the sun rays. The chlorine level in your pool can be checked by using a standard chlorine
test kit.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of injury or electric shock, do not allow children to use this product.
WARNING: Power supply should be installed in a shaded area to protect the transformer from direct sunlight.
WARNING: Do not connect the power supply unit to AC power until the installation is complete.
WARNING: Disconnect the power supply from the outlet when not in use.
WARNING: Do not operate with a damaged cord or power supply.
WARNING: To avoid risk of electrical shock, do not put the power supply in the water.
WARNING: Use of extension cords can result in death or injury.
WARNING: Make sure the power supply is unplugged from the wall when cleaning/servicing the cell assembly.
WARNING: The sole purpose of this product is for use as a chlorine generator as described in this manual; any modification or
other use will void the warranty.
WARNING: Never open the power supply for any reason. Failure to comply will result in loss of warranty.
2
Compliments of www.poolsandstuff.com
To Next Page
Loading...
