The hob operating status with reheating is a transitory condition for rapid achievement
of target temperature of the active hot field, up to the heating power set. It is signaled by the
decimal point lighting up next to the active burner’s digital indicator (5,6,7, fig2).
- If any level of heating power is set for the given hot field, the controller display will show a
number corresponding to the power setting. With this setting, the operating condition with
automatic reheating function will start automatically. This status is additionally signaled by
decimal point on the display corresponding to the given hot field. It takes up to 18 minutes,
depending on the power setting. Then, the hob’s controller switches to automatic heating
cycles.
- You can change the heating power level of the selected sensor while working with automatic
reheating function using the corresponding sensor and following the procedure described above
under. 3.2.
- The automatic reheat operating mode of the given hot field is controlled by an electronic
system.
3.4. Switching off the burners. In order to switch off any of the operating burners, touch the
corresponding sensor, then slide your finger along the slider towards the “key” so that to reduce the
burner’s power setting to “0” (gas supply shutdown). During this operation, the row of LEDs (no
4 fig. 2) showing the power level goes down and the digits decrease from the level previously set to
level “0”. When level “0” is reached and the controller is ready for restarting, the letter “H” will
display after a moment, indicating that the panel is hot in the location of the burner that has just
been shut down. You may also switch off the entire hob. To do so, touch the main shutdown switch
sensor, or press and hold the power setting slider around zero power for some time, having
previously activated the selected sensor for switching down the burner. All working burners will go
off and those just shut down will display the letter “H”.
3.5. Switching the controller lock on and off. The purpose of controller lock is to secure the
hob’s electronic system against accidental startup or changing the power setting of active
burner. To avoid unauthorized activation (e.g. by a child, a drop of water, or an item being placed
on a working controller), switching off or changing heating power settings of burner(s), use the
controller lock as follows:
- touch the sensor /key/ with your finger – no 1 fig. 2 at least twice in 2 seconds’ time. When
pressed shortly twice, the controller will be locked,
- signaling LED lighting up and a sound signal no 2 fig. 2 indicating the controller lock status, a
long sound signal will be heard simultaneously. The hob controller does not respond to any
instructions except for lock status change.
Proceed in a similar way to deactivate the lock status:- touch the sensor with your finger (no 1 fig.
2) twice within up to 2 seconds,
- the signal LED (no 2 fig. 2) goes off, the lock is off, and a sound signal is emitted.
3.6. Residual heat indicator. After a hot field is shut down, it remains hot for a certain time, and
the “H” message is displayed. The above applies to all operating burners being shut down.
Do not touch the hot field during that time, and do not place heat-sensitive
items on the hot fields, to avoid the risk of burning!
When this indicator goes off, you may safely touch the heating pad.
To Next Page
Loading...