Solidyne DX 816 - Line Channel Configuration

*:3%:S4
:*%:9
34%D>!(
  >    = $.  7
8  3:  J4K    J>3K      :F
>=//J%K4
%:34
*    S  :    9%  :
7%=0?8,9"5/PD>
4%%%3;3D9
::
*93!Z/PD
S44%%%
>JK7:%>
D=JK8
%/
* 4 1G+   $0
$:>%-O!
:%7 !89
%7-8D
%-"&:3'(9
%D%>B+K =
*6=%33D>
%'(3
$:369
5C'>>=3:
.C$ P  7 34 P >  95 B95 (8
:  :  %L    %% '$3)
F>@5G""
=9"#*!
"P
  SOLIDYNE
Preamp gain
4-bands EQ. It affect to all
microphones at same time.
Microphone channels are
processed by a
limiter/compressor that start
to work when the signal
reachs +2VU. Compression
action shows on ‘MIC
Compressor’ LED indicator.
EQ ON/OFF
CUE
48V Phantom Power Supply.
Is turned on/off for the inputs
MIC-1, MIC-2 and MIC-3
MAIN FADER. MIC
channels are turned on
with a MASTER MIC-ON
button, located at the
monitoring panel.
The appropriate operation
level is obtained when the
peaks reaches 0VU
OVERLOAD ZONE
The preamp gain must be
adjusted in order to the main fader
works over this indication. If fader
works always over the OVL
indication, there are “RISK OF
OVERLOAD”
BUS assignment The MICs
can be assigned to PGM,
to REC or to both outputs.