48
s
assembly of the fan
1. Step:
installing the stand extension to the base
(only necessary if you require the tall variation
of the fan)
Place the base on the ground. Insert the
three male pins on the stand extension (12)
into the base and press the extension down
until it clicks in place.
Caution: Please make sure you hear the click-sound,
so that the stand has definitely connected to the base.
2. Step:
mounting the rear guard grille (already pre-assembled)
Move the rear guard grill (6) onto
the motor shaft (7) and press it
onto the three pins on the motor
housing, as shown in the figure.
Then also move the securing nut
for the guard grille (5) over the
motor shaft and screw it clockwise,
securely into place.
3. Step:
mounting the fan blade (already pre-assembled)
Place the fan blade (4) onto the motor shaft.
Slide the blade all the way to the back and turn
it until the guide cross clicks into the small pins
on the motor shaft.
The tip of the motor shaft is just visible in the
middle of the fan blade. Place the plastic nut (3)
over the motor shaft and screw it anticlockwise
into place.
Caution: If the fan blade isn't installed correctly, you can't screw
the plastic nut into place.
To Next Page
Loading...
