Safety regulations
ENGLISH 6
1.5 Preparing the equipment for starting
Check the complete machine for operational safety. In addition to the information in the operating and
maintenance instructions (chapter 7), implement the following checks:
• The ON/OFF switch must have an easy action.
• The throttle must have freedom of movement and return to the idle position on its own accord.
• The cutters and contact protection must be tightly secured and in perfect condition.
• Ensure the spark plug cap and the ignition cable are connected firmly. A loose connection may cause
a spark, which can ignite any existing fuel:air mixture - fire hazard!
Should the check reveal any irregularities or recognisable damage (also to the frame), incorrect
adjustments or reduced efficiency of the machine, do not commence work. Take the power tool to a
specialised workshop and have it checked.
1.6 Starting
• Start the machine no less than 3 metres from the refuelling location. Never start the machine in an
enclosed space.
• Ensure that you are standing firmly on the ground when starting. Always start on even ground, with a
firm grip on the power tool.
• Continue with the starting procedure as described in section 5 "Starting/Stopping the engine".
• Check the idle speed setting after starting. The cutter must not move at idle speed.
• Check the blade brake. The blade must come to a halt as soon as you release the throttle safety catch.
When the throttle control lock is released, no drive must be delivered to the cutting blades even in part
throttle operation.
Do not use the power tool In the event of a malfunction Î consult a specialist workshop.
1.7 Maintenance and repairs
Regularly service this machine. Only carry out those maintenance jobs and repairs, which are described in
this manual. A specialised service centre will carry our all other jobs.
• Do not maintain, repair or store the machine near an open flame.
• Before cleaning, maintenance and repair work, always stop the engine first and pull the spark plug
cap. Exceptions: carburettor and idle adjustments.
• For any repairs only use original parts from the manufacturer.
• Do not modify, alter or change the machine as this may impact on the safe operation of the machine
and may lead to accidents and injuries!
1.8 Working with the machine
• Environmental protection:
- Avoid excessive noise and exhaust fumes when operating this power tool, and never run the engine
unnecessarily. Ensure compliance with any local noise regulations.
- Ensure compliance with any local regulations concerning the cutting of hedges or periods where
such work is prohibited.
- Before commencing such work, ensure that no birds are nesting in your hedges. If you do discover
nesting birds, postpone the work or avoid this area when trimming your hedges.
- To avoid harming any other animals you may find in your hedges, check under all hedges before
trimming and scare any animals away.
- Dispose of any cuttings in an environmentally responsible manner (for example, by composting).
• Only use this power tool when it is complete and in a safe condition.
As soon as the engine is running, the power tool generates toxic gases, which may be invisible and
odourless. Never work with the power tool in enclosed spaces. In confined conditions such pits or
excavations, ensure adequate air changes during work.
Do not smoke at the work site and in the immediate vicinity of the power tool. There is an increased
fire hazard!
To Next Page
Loading...