EasyManuals Logo

Solo 457 Operator's Manual

Solo 457
8 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
OPERATOR’S MANUAL & PARTS LIST 456, 457, 456F
If you are missing parts, instructions or have questions, DO NOT take this unit back to the store.
Call 1300 798 022. Solo will send the missing parts/information to you promptly.
STOP
Visit us on the web at www.soloaustralia.com.au Troubleshooting and parts ordering available on-line.
CUSTOMER SERVICE COMMITMENT FROM SOLO’S SERVICE DEPARTMENT: In the event the sprayer you have purchased has missing or damaged parts,
please call 1300 798 022, 9:00am – 5:00pm Mon-Fri. In order to assist your service representative, please have the following information available: sprayer model number,
part description and part number. A parts list is included in your operator’s manual. Solo is committed to your satisfaction and is continuing its efforts to earn your future business.
If you suspect or observe indications that the material may be unsafe
in a Solo sprayer... STOP! Do Not Use or Apply Chemical. ALWAYS
WEAR RUBBER GLOVES, SAFETY GOGGLES AND APPROPRIATE
PROTECTIVE CLOTHING.
Read and follow operating instructions.
• Donotllsprayerovermaximumllmark.Releasingpressureinan
overllconditioncancauseharmfulventingofsprayercontents.
• Relievepressureonlywithsprayeruprightandwhilestandingon
the side of the sprayer opposite the pressure relief valve. Venting of
sprayer contents can occur if liquid is over bottom of relief valve.
• CAUTION:Topreventinjuryfromejectedpumpassemblyand/or
solution,neverstandwithfaceorbodyoverthetopofthetankwhen
pumping, or loosening pump.
• Donotmodifysprayerorpressurereliefvalve.
• Neversprayinthedirectionofhumans,animalsorpropertywhich
mightbeinjuredordamagedbysprayformula.
• Donotusedisinfectants,solventsorimpregnatingagentsunlessrst
tested to ensure they are not harmful to the environment and sprayer.
• Donotuseliquidswithatemperatureabove45°C.
• Rememberthatasprayerwithliquidisasignicantamountofweight
(1kgperlitre).Usecautionwhenbending,leaningorwalking.Bend
onlyatthekneesandsupportyourselfasrequiredtoensurepersonal
safety.
• Donotinatesprayerwithoutliquidinthetank.
• Donotclimbonladders,treesorotherunsteadyorpotentiallyunsafe
structures.
ASSEMBLY INSTRUCTIONS FOR WAND
1. Ensure that the O-ring is on the
non-threaded end of the wand.
2. Insert the non-threaded end of the
wand into the O-ring into the open
end of the shut- off valve.
3. Tighten the screw cap.
WARRANTY
SolobackpacksprayersarecoveredbySolo’sWARRANTY
(2yearsformodels456,457,456F).Solomanufacturedpartswhichfail
duetodefectivematerialorworkmanshipwillberepairedorreplaced
without charge. Refer to Warranty sections for consumer and commercial
use, of this Owners Manual, for full details.
SAFETY PRECAUTIONS
Do not exceed 3 bar (45 psi) pressure.
Do not fill with, use or spray flammable
materials.
Do not use gasoline, acid, acetone, caustic or
potentially injurious chemicals.
• Atthetimeofmanufactureofthissprayer,
we are not aware of any approved plant
protection chemicals which would adversely
affect this sprayer when applied in their usual
concentration.
Observe the recommendations of the
chemical manufacturer.
Prior to removing any part of the sprayer pull the pressure relief
valve to release any pressure in the tank.
Wear rubber gloves, safety goggles and appropriate protective
clothing.
After pumping be sure handle is in the locked down position.
• Individualsshouldbetrainedintheproperuseofthissprayer.Where
training is not available, individuals should study and follow the
procedures detailed in this manual.
• Donotuseacetonebasedchemicals.
WARNING
Chemicals can be harmful to individuals and the environment if
improperly used. In addition, some chemicals are caustic, corrosive,
or poisonous and should be avoided. Read warnings and chemical
manufacturer’s instructions. Solo high density polyethylene sprayers
arettedwithViton®sealswhichareresistanttoawidevarietyof
agricultural, industrial and household chemicals; however, care should
beexercisedtoensurethatsprayercomponentsareclean,functioning
properly, and in a good state of repair before and during use. If in doubt
aboutaparticularchemical,checkwithmanufacturer.
1

Other manuals for Solo 457

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Solo 457 and is the answer not in the manual?

Solo 457 Specifications

General IconGeneral
BrandSolo
Model457
CategoryPaint Sprayer
LanguageEnglish

Related product manuals