Flat spray Hollow Cone spray Brass
Adjustable
nozzle
Jet Stream Plastic
Adjustable
nozzle
1
3
4
2
2
8 8
8
7
2
2
3
8
8
6
2
5
1.Flatspraynozzle
2. Filter
3. Jet cap
4.Swirlplate
5.Nozzlecap
6.Nozzlebody
7.Brassadj.nozzle
8.Nozzleretainingnut
OPERATING FEATURES
Nozzles–YourSolosprayerhasavailablethefollowingnozzlearrangements,toprovideavarietyofspraypatterns.
Item Application Part
Flatspraynozzle
Row treatment 40742631
Jetstreamnozzle
Spot & longer range 4074755
JetstreamnozzleandSwirlplate=hollowcone
Shrubs and bushes
4074755
4074756
PlasticadjustableSpot,nozzle
(Suppliedwith425&475only)
Spot, shrubs &
bushes
4900527
Note: DifferentSolomodelsaresuppliedwithdifferentspraynozzles.
WILL THE PLASTIC MATERIAL LAST?
Only high-grade polyethylene is used. The material is chosen for high
molecularweight,high-impactstrength,andexcellentresistanceto
chemicals and stress. Ultraviolet inhibitors are used in the material to
reduce deterioration caused by sunlight.
HOW HEAVY IS THE UNIT?
Compressionsprayersweighapproximately3kg.
CAN I USE WEED KILLER AND INSECTICIDE
IN THE SAME SPRAYER?
In theory you can, if the sprayer is thoroughly cleaned out with a bleach
water solution of 1:25. In practice, the use of both types of chemicals in
thesameunitisnotrecommendedastherisktoplantscanbehigh.Use
caution when handling any type of chemicals and when cleaning your
sprayer.Donotmixcleaningagents.
SPRAY TIP ASSEMBLY (Spray tips should be assembled as follows for desired spray patterns.)
WHAT SPRAY NOZZLE SHOULD I USE?
Aatspraynozzleissuppliedforsprayingpaths,gardenbeds,and
generalareaspraying.Aconenozzleisalsosuppliedforspotspraying
and for the treatment of bushes and small trees. For spot spraying,
simplyremoveswirlplatefrombehindnozzletip.Savetheswirlplatefor
futureuse.Awideselectionofnozzlessuchasdeector,adjustable,and
anti-driftnozzlesareavailable.
CAN I DO SPOT SPRAYING?
The shut-off valve on the Solo sprayer is well suited for spot spraying.
It’s almost effortless! The shut-off valve handle incorporates a clip which
holds the valve open for area spraying without tiring the operator’s hand. A
pressuregaugemaybeaddedwithincrementsfrom0to6Bar(0-90psi).
In the best interest of continued technological progress, we reserve the right to change
designandcongurationofanyproductwithoutpriororothernotice.Therefore,please
notethattextandillustrationsofthismanualarenottobeconsideredbindinganddonot
constitute a basis for legal or other claims.
No-drip-checkvalve
replaces # 2 on
heavy-duty models
3