Maintenance and Care ; Parts subject to wear and tear ; Guarantee
ENGLISH 15
10.6 Oil level check
Attention: The engine oil affects the lawn mower‘s
efficiency and life span. Never operate the engine
without oil or with little oil. Major engine damage
can occur. The optimum viscosity depends on
where the lawn mower is used (air temperature
and altitude) and can be found in the engine
owners manual.
Checking Oil level:
Observe the notes and instructions in the type-
speci.c engine operating instructions.
• Place lawn mower
horizontally with all
wheels on the ground.
• Turn oil tank cap
counter-clock-wise
(14), and remove.
Wipe off dipstick.
• Place dipstick back
into filler pipe.
• Remove dipstick, hold horizontally and read oil
level. Oil level has to be between the
"MAXIMUM" and "MINIMUM" markings.
Changing Oil
The engine oil may be drained via the oil drain
screw or the oil filler opening. Blade and blower
wheel need to be removed to reach the oil drain
screw (illustration 9). Observe especially the
service instructions in the separate engine owners
manual.
When draining via oil filler opening (14): Tilt the
warm mower (with fuel tank empty and closed oil
filler ) slowly over the side of the filler opening.
Remove oil filler cap and catch old oil in a
container. Wait several minutes until oil is drained.
Dispose off the old oil in accordance with local
ordinances.
After changing oil, always wash hands with a
scouring agent, soap and water.
Attention: Never simply throw away used engine
oil and gear lubricant (environmental protection).
Collect used oil in authorized containers and
submit to the proper recycling facility.
11. Parts subject to wear and tear
Various parts are subject to application-specific
wear or to normal wear and must be replaced in
good time if necessary. The following parts are
subject to normal wear and are not covered by the
manufacturers guarantee:
• Blade and blade fixing
• Friction pads
• Air filter
• Spark plug
• Fluids, such as engine and gearbox oil
• Drive belts on lawnmowers with self-drive
12. Guarantee
The manufacturer guarantees problem free quality
and will cover the cost of replacing parts which are
found to be faulty in material or show
manufacturing defects within the prescribed
guarantee period after the date of purchase.
Please note that specific guarantee conditions may
differ from country to country. When in doubt,
please ask the vendor of the goods. The vendor of
the product is responsible for guarantee
applications.
We hope you will understand that we cannot be
liable for damage resulting from these causes:
• Non-compliance with operating instructions.
• Neglecting required maintenance and repair
jobs.
• Damage caused by improper carburettor
adjustment.
• Wear from normal use.
• Obvious overload by continuously exceeding
the upper performance limit of the product.
• Using non-approved tools.
• Use of force, improper treatment, misuse and
accidents.
• Damage from excessive heat due to dirt build
up around the cooling fan housing.
• Attempted adjustments and repairs by non-
qualified persons.
• Use of unsuitable spare parts or non-original
parts if such parts are the cause of the
damage.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the
hire or rental industry.
Normal cleaning, adjustments or maintenance jobs
cannot be claimed as part of the guarantee.
All guarantee work must be carried out by a service
centre authorized by the manufacturer.
Fig. 11
To Next Page
Loading...
