Parts subject to wear and tear ; Guarantee ; CE Declaration of conformity
ENGLISH 25
13. Parts subject to wear and tear
Various parts are subject to application-specific or
normal wear and must be replaced in good time, when
required. The following parts are subject to normal wear
and are not covered by the manufacturer's guarantee:
• Air filter
• Fuel filter
• All rubber parts which come into contact with fuel
• Clutch
• Spark plug
• Starter
• Cutting tools
• Operating materials
• Cutting tools: guide bar / saw chain
• Vibration damping elements made of rubber
14. Guarantee
The manufacturer guarantees trouble-free quality and
will cover the cost of replacing parts which are found to
be faulty in material or workmanship within the
prescribed guarantee period after the date of purchase.
Please note that specific guarantee conditions may vary
from country to country. If in doubt, ask your equipment
vendor. He is responsible for guarantee matters.
We hope you will understand that we cannot be liable for
damage resulting from the following causes:
• Non-compliance with the operating instructions.
• Neglecting essential maintenance and repair work.
• Damage caused by incorrect carburettor
adjustment.
• Wear in normal use.
• Obvious overload by continuously exceeding the
maximum performance limit of the product.
• Using non-authorised tools.
• Use of force, incorrect treatment, misuse and
accidents.
• Damage from excessive heat due to dirt build-up
around the cooling fan housing.
• Attempted adjustments and repairs by unqualified
persons.
• Use of unsuitable spare parts or third party parts, if
these are the cause of the defect.
• Use of unsuitable or stale fuel.
• Damage caused by using the product in the hire or
rental industry.
Normal cleaning, adjustments or maintenance work fall
outside the guarantee provisions.
A service centre authorised by the manufacturer must
carry out all guarantee work.
15. CE Declaration of conformity
In accordance with EG Directives 98/37/EC, 2000/14/EC
and
RL - 2004 - 108 EG, SOLO Kleinmotoren GmbH,
Stuttgarter Strasse 41, D-71069 Sindelfingen, being
solely responsible, states that the product referred to in
this declaration complies with the requirements of the
Machinery Directive.
Description of product: chain saw
Model/type description / Sound power level:
635ECO 636 642 643IP
Guaranteed sound 109 109 110 110 dB(A)
Actual sound 108 108 109 109 dB(A)
(EN ISO 3744, EN ISO 22868)
Applied standards: DIN EN ISO 11681,
DIN EN ISO 14982
Conformity assessment procedures
(98/37/EG)! Appendix IV, (2000/14/EG)! Appendix V
Nominated location acc. to 98/37/EC:
Intertek Deutschland GmbH
Nikolaus-Otto-Str. 13
D 70771 Leinfelden-Echterdingen
Registration number: 0905
Storage location for the technical documentation
according to 2000/14/EC and 89/336/EC:
Solo Kleinmotoren GmbH
Stuttgarterstr. 41
D-71069 Sindelfingen
This declaration of conformity loses its validity, if the
equipment is converted or modified without the
manufacturer's consent.
Sindelfingen,
1
st
August 2007
SOLO Kleinmotoren GmbH Wolfgang Emmerich
Executive Director
In the best interest of continued technological progress
we reserve the right to change the design and
configuration of any product without prior notice.
For that reason, no claims can be accepted with
reference to text and illustrations in this manual.
To Next Page
Loading...
