05
Before Installation
• Ensure you remove all the packaging, taking care to
discard waste responsibly.
• Under no circumstances should you install or use a
damaged appliance.
• Always move the appliance carefully. Do not use the
machine door or the handle of your oven when lifting
the appliance.
• When the oven is first switched on, it may give off an
unpleasant smell. This is due to the bonding agent used
for the insulating panels within the oven. Please run the
new empty oven with the conventional cooking function,
250 °C for 90 minutes to clean oil impurities inside the
cavity.
• During the first time use, it is completely normal that
the oven will show slight signs of smoke and unpleasant
odours. Please wait for the smell to clear before putting
food into the oven.
• Please use this product under the open environment.
• The appliance and its accessible parts become hot
during use. Care should be taken to avoid touching
heating elements.
• If the surface is cracked, switch off the appliance to
avoid the possibility of electric shock.
• During usage, the appliance can become very hot.
Care should always be taken to avoid touching heating
elements inside the oven.
• Ensure that the appliance is switched off before
replacing the oven lamp to avoid the possibility of
electric shock.
• The means for disconnection must be incorporated
in the fixed wiring in accordance with the wiring
specifications.
• Accessible parts may become hot during use.
• An all-pole disconnection means must be incorporated
in the fixed wiring in accordance with the wiring rules.
• The appliance must be installed by an authorised
technician and put into use. The manufacturer
is not responsible for any damage that might
be caused by defective placement, and installation by
unauthorised personnel.
• To arrange an authorised technician please contact our
friendly support team at 1300 11 HELP (4357).
Electrical connection
CAUTION: Risk of fire and electrical shock!
• The appliance must be earthed.
• Ensure the information on the oven’s rating plate agrees
with the power supply. If not, contact an electrician.
• Always use a correctly installed shockproof socket.
• Do not use any multi-plug adapters or extension cables.
• Connect the mains plug to the mains socket only at the
end of the installation. Make sure that there is access to
the mains plug after the installation. Do not connect the
appliance plug with a power connection board.
• Do not pull the mains cable to disconnect the appliance.
Always pull the mains plug.
• Never touch the mains cable or plug with wet hands.
WARNING: If the supply cord is damaged, it must be
replaced by the manufacturer or its service agent or
similarly qualified person in order to avoid a hazard.
WARNING: All electrical work must be done in
accordance with local and national electrical codes
as applicable and should be undertaken by licensed
and qualified persons only. Failure to follow these
instructions can result in death, fire or electrical shock.
Disposal
• This appliance is labeled in compliance
with European directive 2012/19/EC
for Waste Electrical and Electronic
Equipment (WEEE). By ensuring that this
appliance is disposed of correctly, you
will help prevent any possible damage
to the environment and to human
health, which might otherwise be caused
if it were disposed of in the wrong way.
• The symbol on the product indicates that it may not be
treated as normal household waste. It should be taken
to a collection point for the recycling of electrical and
electronic goods.
• This appliance requires specialist waste disposal. For
further information regarding the treatment, recovery
and recycling of this product please contact your local
council, your household waste disposal service, or the
shop where you purchased it.
To Next Page
Loading...