8
WARNING!
To prevent leakage or water damage, follow the instructions in this chapter carefully:
• Do not kink, crush, modify, sever or protract the inlet hose or drain hose.
• Position drain hose properly ,otherwise damage might result of water leakage.
• If drain hose is too long, do not force it into washing machine as it will cause abnormal noises.
Use an upper drain system to place the end of drain hose:
LEVELLING THE WASHING MACHINE
WARNING!
The lock nuts on all four feet must be screwed tightly against the housing.
1. Check if the legs are closely attached to the cabinet. If not, please turn them to their original
positions tighten the nuts.
2. Check alignment of the product with a spirit level and if required, correct.
3. Loosen the lock nut and turn the feet until it closely contacts with to the oor.
4. After being locked properly, press four corners again to make sure that they has been
adjusted properly.
Operating Instructions
To Next Page
Loading...
Need help?
General
