What to do if my Solt GGSTLW55B shows "E3" error for lid not closed?
If your Solt Washer displays the "E3" alarm, it means the lid wasn't closed before washing or spinning. To resolve this, close the lid and press the "Start" button.
What to do if my Solt GGSTLW55B is draining abnormally?
If your Solt Washer is draining abnormally, ensure the water drain hose isn't placed too high or sealed in a pond. Also, check if the internal rubber ring of the drain valve is blocked by dirt and ensure that the water tap is opened.
What to do if Solt GGSTLW55B Washer displays "E4" alarm for washing staying at one side?
If your Solt Washer is showing an "E4" error, it indicates that the washing is staying on one side. To fix this, manually balance the clothes in the barrel by hand.
Why is my Solt GGSTLW55B Washer spinning abnormally?
If your Solt Washer is not spinning correctly, it could be due to several reasons: * The door lid might not be closed properly. * Clothes may be piled largely on one side or excessively placed. * The washer isn't stable or is inclined. * The motor belt is loosened. To solve it, close the lid and press the "Start" button or manually balance the clothes in the barrel by hand.
What does "E1" error mean on my Solt GGSTLW55B Washer and how do I fix it?
If your Solt Washer displays the "E1" alarm, it indicates an abnormal water intake. Ensure that the water tap is opened.
Why is my Solt GGSTLW55B not washing?
If your Solt Washer is not washing, it could be due to: * A power outage or a blown fuse. * Low power supply voltage. * The water level reaching the required level. * The washer being set to "Delay" mode. In any of these cases, switch the washing machine off at the power point or at the fuse box.
What does "E2" error mean on Solt GGSTLW55B Washer?
If your Solt Washer displays the "E2" alarm, it means the water drain hasn't finished. Check the water level sensor and drain pump.
How to fix no water flowing into my Solt GGSTLW55B Washer?
If your Solt Washer is not filling with water, make sure the water tap is opened. The issue might arise if the power is off, the water supply is cut off, the inlet hose isn't properly connected, the filtering screen is blocked, the coil of the inlet valve is damaged, or the "Start/Pause" button was pressed after powering on.
Explains the meaning of signal words used for safety warnings.
Covers electrical safety, child safety, and risks of fire or explosion.
Details safety precautions for installation, handling, and using the appliance.
Outlines necessary steps and conditions for installing the washing machine.
Instructions for emergency situations and a table listing common faults and their inspection items.
Explains common error codes displayed by the machine and provides solutions for each.
To Next Page
General
