Page 3 of 9 3118.B
NOTE: GROUNDING RELIABILITY CAN ONLY BE ACHIEVED WHEN
THIS EQUIPMENT IS CONNECTED TO AN EQUIVALENT
RECEPTACLE MARKED "HOSPITAL ONLY" OR "HOSPITAL
GRADE."
CAUTION: POWER MUST BE OFF UNTIL MINIMUM FLUID LEVEL IS
POURED INTO DRAPE.
TEMPERATURE CONTROLS
1. Upper indicator (PV - Present value) indicates present temperature of
solution.
2. Lower indicator (SV - Set value) indicates the temperature the solution is
set to warm to.
3. AL lights when Present Value is 4
o
F greater than Set Value.
4.
o
F indicates solution/set point temperature readouts are in Fahrenheit.*
5. SP1 lights when heating element is active.
6. SP2 is not applicable.
7. ▲ ▼ used to increase/decrease temperature setting (SV).
*Centigrade readout available upon request.
To Next Page
Loading...