Page 7 of 9 3118.B
TROUBLESHOOTING
ORS-2000 Series Irrigation Solution Warmer
Problem: Corrosion in basin of Solution Warmer.
O.R. Solution: Scrub basin with a non-abrasive cleanser to remove corrosion.
Problem: Power switch does not light up.
O.R. Solution: Check to make sure that the Solution Warmer is plugged in and the
outlet is active. Inspect the power cord and plug for wear or abuse. If power switch
still does not light up, contact ORS.
Problem: Solution Warmer does not heat up.
O.R. Solution: The light on the LED display of the Temperature Controller should be
on. If the light on the LED still is not on, contact ORS. If the light is on, make sure the
temperature is adjusted properly (see page 3). If the temperature adjustment is
correct but the Solution Warmer does not heat up, contact ORS.
Problem: Solution temperature does not reach set point temperature.
O.R. Solution: Make sure that the temperature is adjusted properly (see page 3). If
the temperature adjustment is correct, inspect the drape. The drape should be evenly
distributed and in full contact within the basin walls. Avoid big folds or air pockets in
the bottom and sides of the basin. If this does not correct the problem, contact ORS.
Problem: Solution temperature has unusual fluctuation readings.
O.R. Solution: The drape should be evenly distributed and in full contact within the
basin walls. If the solution temperature still shows unusual fluctuation, contact ORS.
Problem: Small amount of water left in the basin after use.
O.R. Solution: It is normal for a small amount of water to remain in the basin due to
condensation. Dry the basin with a lint free cloth and isopropyl alcohol as per
maintenance instructions on page 4.
WARNING: If the Solution Warmer does not operate properly, contact ORS.
O.R. Solutions, Inc., can be contacted by telephone at (800) 343-6771
3901 Centerview Drive, Suite L, Chantilly, VA 20151
To Next Page
Loading...
