Solwave 180MWAS12T - Options Customization

10
DO NOT power spray
No metal pans
Options such as single or double digit programming, beep volume, and
maximum cooking time can be changed to suit individual preferences.
To change options:
1. Open oven door.
• If door is closed or RESET pad is pressed before programming is complete,
changes are discarded and microwave exits programming mode.
2. Press and hold pad 2 for approximately 5 seconds.
• This begins options mode.
• Microwave will beep and
0P: displays.
3. Press number pad that controls option to be changed.
• See table below for options.
• Current option will display.
4. Press number pad again to change the option.
• Each time pad is pressed, option will change.
• Match code displayed with code for desired option.
5. Press START pad to save changes.
• To change additional options, repeat steps 3 and 4.
• Changes appear after door is closed or STOP/RESET pad is pressed.
Numbered Pads
Display
Options
1
End of Cycle Beep
OP:10
OP:11
OP:12
3 second beep.
Continuous beep until door is opened.
5 beep bursts until door is opened.
2 OP:20 Eliminates beep.
Key Beep Volume OP:21 Sets volume to low.
OP:22 Sets volume to medium.
OP:23
Sets volume to high.
3
Key Beep
OP:30
OP:31
Prevents beep when pad is pressed.
Allows beep when pad is pressed.
4
Active Display
OP:40
OP:41
OP:42
15 seconds after oven door is opened, keyboard disabled.
30 seconds after oven door is opened, keyboard disabled.
1 minute after oven door is opened, keyboard disabled.
OP:43 2 minutes after oven door is opened, keyboard disabled.
5
On-the Fly Cooking
OP:50
OP:51
Prevents
Allows .
.
6
Reset to Ready Mode
OP:60
OP:61
Opening oven door does not reset oven back to ready mode.
Opening oven door resets oven back to ready mode.
7
(some models)
Maximum Heating Time
OP:70
OP:71
Allows 60 minutes of heating time (some models).
Allows 10 minutes of heating time.
8
Manual Operation
OP:80
OP:81
Allows use of preprogrammed pads only.
Allows use of manual time entry and preprogrammed pads.
9
(some models)
Double Digit Operation
OP:90
OP:91
Allows 10 (0-9) preprogrammed pads.
Allows 100 (00-99) preprogrammed pads.
0 OP:00 Do not display message.
Clean Filter Message OP:01 Display message for 24 hours every 7 days.
OP:02 Display message for 24 hours every 30 days.
OP:03 Display message for 24 hours every 90 days.