6
Installation
Unpacking Oven
• Inspect oven for damage such as dents in door or
dents inside oven cavity.
• Report any dents or breakage to source of purchase
immediately. Do not attempt to use oven if damaged.
• Remove all materials from oven interior.
• If oven has been stored in extremely cold area, wait a
few hours before connecting power.
Radio Interference
Microwave operation may cause interference to radio,
television, or a similar oven. Reduce or eliminate
interference by doing the following:
• Clean door and sealing surfaces of oven according to
instructions in Owner’s Manual.
• Place radio, television, etc. as far as possible
from oven.
• Use a properly installed antenna or cable on radio,
television, etc. to obtain stronger signal reception.
Oven Placement
• Do not install oven next to or above source of heat,
such as pizza oven or deep fat fryer. This could cause
microwave oven to operate improperly and could
shorten life of electrical parts.
• Do not block or obstruct oven filter. Allow access for
cleaning.
• Install oven on level countertop surface.
A - Allow at least 2 in / 5.1 cm of clearance
around top and sides of equipment.
Proper air flow around equipment cools
electrical components. With restricted
air flow, oven may not operate properly
and the life of electrical parts is
reduced.
B - There is not an installation clearance
requirement for the back of the oven
C – Allow at least 1 in / 2.54 cm clearance
around sides of oven
• Oven stacking is allowed using stacking
bracket located on oven back panel top hinge
side corner
• Using stacking brackets on back panel of
ovens remove screws from stacking brackets
and reattach them to back panel between both
ovens securing them together using back
panel screws
To Next Page
Loading...
