SOMFY Axovia Series User Manual

M1 is always the motors who start the first.
Screw the wires of the motor cable onto the
connector, comply with the colors.
2 x 1 mm
2
mini - 7m maxi
Power supply 230V
black green
black green
brown blue
Blue Brown
Connecting motors Axovia 200A, 250A, 150S.
®
AXOVIA 150S AXOVIA 200A
AXOVIA 250A AXOVIA 400C
It’s essential to turn off the power supply at
the circuit breaker before working on the AXOVIA
Internal manual unlocking:
Open the cover, disconnect the motor M1 from the
electronics pull on the gate to open it.
Motor
Click the motor into slot M1
Comply with the colors
Electronic / main power supply
Connect the mains power supply wires to the connection bar.
Comply with the phase, neutral and earth configurations.
Blue or black Brown or
green
Blue or
black
Brown or
Green
Motor on the right seen from inside.
Motor on the left seen from inside.
Connecting motors Axovia 400C
Brown or
Green
Blue or
Black
Phase
Neutral
Earth
Programmation tips

SOMFY Axovia Series Specifications

General

Type	Garage Door Opener
Maximum Door Height	2.5 m
Operating Temperature	-20°C to +60°C
Remote Control	Yes
Speed	0.15 m/s
Power Supply	230 V AC
Safety Features	Obstacle detection

Summary

AXOVIA Motor Connection Guide

Connecting AXOVIA 150S, 200A, 250A Motors

Instructions for wiring and connecting AXOVIA 150S, 200A, 250A motors, including color compliance.

Connecting AXOVIA 400C Motor

Wiring instructions for AXOVIA 400C motor, including right/left side and power supply connection.

Internal Manual Unlocking Procedure

Steps to manually unlock the gate by disconnecting the motor from the electronics.

AXOVIA Gate Operation and Control

Unit Presentation: Buttons and LEDs

Explains the functions of control buttons (B1-B4) and status LEDs (V1-V4) on the unit.

Manual Gate Operation Check

Guide to checking manual gate movement and motor response for correct operation.

Programming and Deleting Remote Controls

Instructions for adding new remote controls and removing existing ones from the system.

AXOVIA Self-Learning and Modes

Self-Learning Phase Overview

Prerequisites and general steps for the self-learning phase of the gate system.

Semi-Automatic Mode Configuration

Steps to configure the gate for semi-automatic operation.

Fully Automatic Mode Configuration

Steps to configure the gate for fully automatic operation and set open time delay.

End Stop Detection for Self-Learning

Importance of end stops and troubleshooting if they are not detected during self-learning.

AXOVIA Installation and Safety

Gate End Stop Installation Requirement

Essential requirement for gate end stops to limit travel and position.

Connecting Safety Photocells

Wiring instructions for transmitting and receiving safety photocells for obstruction detection.