SOMFY Inteo SOLIRIS IB User Manual

1
SOLIRIS IB
Supply:
Degree of protection:
Class:
Operating temperature:
Environmental conditions:
Relay contacts load:
33 mm 17 mm
EN60669
EN50081-1
EN50082-1
SOLIRIS IB is a wind and sun automatic control system for an Inteo BUS line (IB Bus).
The wind speed and amount of sunshine are measured by a combined sensor.
A rain sensor can also be connected.
When the sun shines,the awning/blind is activated automatically, either fully or to an indi-
vidually programmed intermediate position.
A dynamic retraction delay avoids frequent activation commands caused by varying light
conditions. Manual operation is also possible and the sun function can be switched off.
If the wind is too strong the awning/blind is automatically retracted and manual operation
is blocked. The wind function is a safety function and is always activated.
220 – 240V ~ 50/60Hz
IP 40
II
+5°C to +40°C
dry living areas.
500 mA/50VDC
Setting up,testing,commissioning and troubleshooting for this equipment should only be car-
ried out by a trained electrician. Before starting work,disconnect the power to all connecting
wires,and take steps to prevent their accidental reconnection. Correct operation is only guar-
anteed when professionally installed and power supply is adequate.
!
80 mm
80 mm
INSTALLATION guide
Ref.9007510
inteoSOLIRIS IB
1
Characteristics:
2
Installation:
We reserve the right to make changes due to technical improvements.

SOMFY Inteo SOLIRIS IB Specifications

General

Brand	SOMFY
Model	Inteo SOLIRIS IB
Category	Control Systems
Language	English

Summary

Installation

Mounting the SOLIRIS IB

Guide for mounting the SOLIRIS IB unit in connection boxes or surface caps.

SOLIRIS IB Terminal Layout

Detailed diagram of terminal connections for the SOLIRIS IB control unit and sensors.

Settings

Wind and Sun Control Settings

Configuration and testing of wind and sun detection thresholds and functions.

Rain Sensor Integration

Connecting an optional rain sensor for automatic retraction of blinds/awnings.

Programming

Operating Mode Programming

Setting the SOLIRIS IB for awning or Venetian blind operation modes.

Intermediate Position Programming

How to program, reach, and cancel a custom intermediate position for automated blinds.

Slat Tilting Programming

Programming and cancelling slat tilting operations for Venetian blinds.

Demo Mode Settings

Activating and quitting demo mode to shorten reaction times for product demonstrations.