SOMFY inteo TELIS SOLIRIS RTS

To Next Page

Characteristics :

The TELIS SOLIRIS RTS is a SINGLE CHANNEL hand-held transmitter

compatible with the SOLIRIS receiver RTS

Commands are transmitted by radio (frequency 433.42 MHz).

❏

Power: 3V lithium battery, CR 2430 type

❏

Protection index: IP 30

❏

Operating temperature: +5°C to +40°C

❏

Class III product

❏

Normally polluted environment

Programming :

• Press the PROG button of the SOLIRIS receiver RTS until its LED lights. This indicates that the receiver

is ready for one minute to memorise the address of the transmitter. After this time limit, the LED goes out.

• Press the programming button on the backside of the TELIS SOLIRIS RTS with a ball-

point pen until the LED of the SOLIRIS receiver RTS blinks.

➭ The address of the transmitter is memorized by the RTS receiver which automati-

cally quits its programming mode.

INITIAL INSTALLATION

inteo TELIS SOLIRIS RTS

I N S TA L L AT I O N

g u i d e

Memorise a TELIS SOLIRIS RTS in the memory of a SOLIRIS receiver RT S

TWO POSSIBILITIES

Repeat the same procedure as described in chapter 2A.

• Press more than two seconds on the programming button of a TELIS SOLIRIS RTS already memorized in

the SOLIRIS receiver RTS in order to “wake up” the receiver.

➭ the both LEDs of the TELIS SOLIRIS RTS light on, indicating that the SOLIRIS receiver RTS is in

its programming modefor one minute.

• Press

b r i e f l y the programming button of the new control you wish to memorise.

➭ The address of the control is memorised in the SOLIRIS receiver RTS which automatically quit its

programming mode.

EXISTING INSTALLATION

Add another control (TELIS 1/4 RTS; CENTRALIS RTS ) in the memory of the SOLIRIS receiver RT S

120 mm

45 mm

17 mm

51 mm

23 mm

102 mm

Hereby, SOMFY, declares that this equipment is in compliance with the

essential requirements and other relevant provisions of Directive

1999/5/EC.

A Declaration of Conformity is available at the web address

www.somfy.com Heading CE

Need help?

Do you have a question about the SOMFY inteo TELIS SOLIRIS RTS and is the answer not in the manual?

Summary

Product Characteristics

Programming the Receiver

Initial Installation and Pairing

Memorise a TELIS SOLIRIS RTS transmitter into the SOLIRIS receiver RTS memory.

Adding Controls to Existing Installation

Add new or existing RTS controls to a SOLIRIS receiver RTS.

Deleting Transmitters from Memory

Remove a transmitter's address from the SOLIRIS receiver RTS memory.

Using the Transmitter

Basic Commands: Up, Down, Stop

Activate the awning's movement in corresponding directions or stop it.

Wind and Sun Configuration

Configure receiver operation based on wind and sun sensor inputs.