SOMFY inteo User Manual

L = Mains phase
N = Mains neutral
C = common
▲ = UP
▼ = DOWN
KEY SWITCH
Blue
Brown
▼▲
2 x 1,5 mm
2
Neutral
Phase
MAINS
230V - 50Hz
Dry contacts TRANSMITTER
NCL
▼
▲
2
13
4
The DRY CONTACT TRANSMITTER is a RTS control that can be controlled driven by a key swit-
ch,a paddle switch, a Centralis IB or a dry contacts rain sensor.
The UP or DOWN radio commands are achieved when the UP or DOWN inputs (▲▼) are connec-
ted with the common input (C). The STOP command is achieved when the three inputs (▲▼ C)
are conected together.
Hereby, SOMFY, declares that this
equipment is in compliance with the
essential requirements and other rele-
vant provisions of Directive 1999/5/EC.
A Declaration of Conformity is available
at the web address www.somfy.com
Heading CE
L = Mains phase
N = Mains neutral
C = common
▲ = UP
▼ = DOWN
CENTRALIS IB
+
C
Set the switch on
the "
-" position
▼▲
+
-
2 x 1,5 mm
2
Neutral
Phase
MAINS
230V - 50Hz
Dry contacts TRANSMITTER
-
NCL
Blue
Brown
45 mm
usable in EU, CH
•
Supply : 220-240V 2,5A 50/60Hz
•
Fuse : 3,15A
•
Transmission timing : min0,5 sec.
max10 sec.
•
Frequency : 433.42 MHz
•
Protection index : IP30
•
Temperature : +5°C to +40°C
•
Class II product
80 mm
80 mm
R
PROG
▲,S,▼,S
LED
Programing
button
Built-in manual
security control
C
5
4
3
2
1
SUPPLY
230V 50Hz
Phase
Neutral
Earth
C
5
4
3
2
1
SUPPLY
230V 50Hz
Phase
Neutral
Earth
This device must be installed and programmed by qualified installers for whom this instruction is inten-
ded.
Before connecting the unit, read the instructions carefully.
1
Characteristics
2
Installation
INSTALLATION guide
Ref.5006405A
inteo DRY CONTACT TRANSMITTER
We reserve the right to make changes due to technical improvements.
DRY CONTACT TRANSMITTER
Cabling of a CENTRALIS IB
Cabling of a Key switch
notice dry contact 10/03/03 16:23 Page 1

SOMFY inteo Specifications

General

Brand	SOMFY
Model	inteo
Category	Transmitter
Language	English

Summary

Dry Contact Transmitter Characteristics

Installation Guide

Cabling of a CENTRALIS IB

Details the wiring for connecting the dry contact transmitter to a Centralis IB unit.

Cabling of a Key switch

Provides instructions for wiring a dry contact key switch to the transmitter.

Cabling of a Rain Sensor

Mounting Options

Programming Procedures

Initial Installation Programming

Steps to record the first dry contact transmitter with the RTS receiver.

Adding a New Transmitter

Procedure to add a new dry contact transmitter to an existing RTS receiver.

Deleting a Transmitter

Instructions on how to delete a dry contact transmitter from the RTS receiver.