To Next PageTo Next Page
Need help?Do you have a question about the SOMFY EOLIS Inteo Wind Control and is the answer not in the manual?
General| Brand | SOMFY |
|---|---|
| Model | EOLIS Inteo Wind Control |
| Category | Control Unit |
| Language | English |
Single motor control for residential use with wind sensor and low voltage switch. Features auto retraction and intermediate positions.
Mount control close to motor, connections facing down. Avoid metallic surfaces to prevent radio interference.
Connect high/low voltage wires as per diagram. Prioritize low voltage wiring. Use strain relief fittings for weatherproofing.
Place sensor near awning, avoid obstructions. Connect to control with cable (max 100 ft). Ensure accurate readings.
Locate the low voltage switch a maximum of 100 feet away from the Eolis control unit.
Wire control as per diagram, turn on breakers. Operate motors DOWN and verify correct wiring.
Adjust wind sensitivity by rotating the wind adjustment knob to the desired setting.
Use UP, DOWN, and STOP buttons on the low voltage switch to control the motorized treatment.
Eolis retracts awning/shutter after 2s of high wind. Ignores other commands. Returns to normal when wind drops.
