Need help?Do you have a question about the SOMFY PERGOLA io LOUVER CONTROL and is the answer not in the manual?
General| Brand | SOMFY |
|---|---|
| Model | PERGOLA io LOUVER CONTROL |
| Category | Controller |
| Language | English |
Details the intended use and compatibility of the PERGOLA io LOUVER CONTROL with specific drives.
Outlines the conditions for warranty and Somfy's liability regarding product use and installation.
Provides critical safety warnings (DANGER, WARNING, PRECAUTION, CAUTION) related to installation.
Details the physical assembly process, including dimensions and mounting hardware.
Explains the upper section of the unit and its connection terminals.
Explains the lower section of the unit and its connection terminals for drives and sensors.
Guides through the initial setup and configuration process for the control system.
Offers practical guidance and troubleshooting tips to ensure a successful installation.
Provides specific physical dimensions of the unit in millimeters and screw recommendations for mounting.
Details wiring precautions and steps for inserting cables into the unit's glands and connectors.
Illustrates and describes wiring for the 24 V DC power supply and the Ondeis 24V rain sensor.
Shows wiring diagrams for Pergola Tilt io with or without encoder, and for two drives with encoder.
Explains how to switch on power and briefly press Up/Down to pre-program the control point.
Provides mandatory steps for synchronizing two drives, requiring identical drives with encoders.
Guides on how to check and correct the motor rotation direction using Up and My buttons.
Details three methods for setting end limits based on the motorized product used.
Explains how to set end limits automatically by pressing Up/Down, then My button.
Guides manual closing limit setting and automatic opening limit setting using Down, Up/My buttons.
Guides manual opening limit setting and automatic closing limit setting using Up, My/Down buttons.
Explains that programming the control point is possible only after setting the end limits.
Describes programming a pre-programmed control point by pressing its PROG button.
Details steps to program a non-pre-programmed control point by cycling power and pressing buttons.
Lists common product operation issues (e.g., non-operation) and their possible causes and solutions.
Explains how to reset only the manual end limit positions using Up/Down and My buttons.
Explains how to add or delete one-way io control points by pressing the PROG button.
Details the functionality and configuration of various sensors like freeze, rain, wind, and sun.
Describes the function of the snow detection sensor and its default settings.
Explains the wind detection feature and its default wind position settings.
Describes the sun detection feature and its default 'My position' or down end limit behavior.
Details how the drive stops and performs a release movement when an obstacle is detected.
Guides on how to adjust the obstacle detection sensitivity level from 1 to 3.
Explains how to adjust the force for closing or opening the slats to levels 1 to 3.
Provides steps to reset the drive to its original factory configuration, deleting all settings.
Explains how to use the Up, Down buttons for movement and the Scroll function for tilting slats.
Details the functions of the 'My' button, including stopping the product and setting favourite positions.
Explains how to program a new 'my' position or delete the old one.
Addresses operational issues, such as the product not operating, and suggests checking the control point battery.
Advises contacting a professional to replace a lost or broken Somfy control point.
To Next Page